Makita BFT081F Uživatelský manuál

Models No. DescriptionPRODUCTTECHNICAL INFORMATIONCONCEPT AND MAIN APPLICATIONS SpecificationStandard equipmentOptional accessoriesP 1 / 10Note: The s

Wiring diagramP 10/ 10[2] Wiring Around Clutch CaseLead wiresof Switch unitPinClutch casePut the sag of the lead wires into this openingas illustrated

P 2 / 10 Repair[2] LUBRICATIONApply Makita grease N. No.2 to the following portions designated with the black triangle to protectparts and product fro

3) -2. Disassembling/Assembling Clutch Case SectionSpindle1) Remove the bit holder section using Makita repairing tool No.1R291, etc.2) Remove M4x4 (+

P 4 / 10 It is recommended to wholly replace Clutch Assembly when the Clutch section is broken. However, we describe below how to disassemble/assemble

1) Remove Carbon brushes from inside of Brush holders.2) Remove Clutch case from Motor section, and then separate Housing L from Housing R by removing

3) Install Lock washer on Gear case. (Fig. 13) Install Motor bracket onto Gear case by turning it clockwise until it is locked. (Fig. 14)4) Complet

1) After removing F/R change lever, remove the screw that fastens the micro switch. Then pull off the micro switch from Trigger switch as illustra

P 8/10Color index of lead wiresBlack WhiteRedOrange BlueYellowPurple GrayCircuit diagramMicroswitch(On/Offfunction)ReversefunctionMDC Motor(End bell)S

[1] Wiring in Housing Route the endbell lead wires (black, red)beside each side of the LED cover on Controller.ConnectorRoute the lead wires so that t