Makita HP2010N Uživatelský manuál

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.www.makitatools.comH

10MAINTENANCECAUTION:• Always be sure that the tool is switched off andunplugged before attempting to perform inspection ormaintenance.To maintain pro

Memo11

Memo12

13First-ClassPostageRequiredPost Office willnot deliverwithout properpostage.Makita U.S.A., Inc.14930 Northam StreetLa Mirada, CA 90638-5753FoldCut

141. This product was purchased from:Home CenterHardware/Lumber StoreTool DistributorIndustrial SupplyConstruction SupplyOther ( )

15FACTORY SERVICE CENTERS1-800-4-MAKITARETAIN THIS PORTION FOR YOUR RECORDSARIZONA3707 E. Broadway Rd., Ste. 6 Phoenix, AZ 85040 (602) 437-2850CALIFOR

WARNINGSome dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Calif

2SPECIFICATIONS• Manufacturer reserves the right to change specifications without notice.• Specifications may differ from country to country.GENERAL S

3Electrical Safety4.Double insulated tools are equipped witha polarized plug (one blade is wider thanthe other.) This plug will fit in a polarizedoutl

421.Check for misalignment or binding ofmoving parts, breakage of parts, and anyother condition that may affect the toolsoperation. If damaged, have t

54.Keep hands away from rotating parts.5.Do not leave the tool running.Operate the tool only when hand-held.6.Do not touch the bit or the workpieceimm

6FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function on thetool.Switch act

7Speed changeTwo speed ranges can be preselected with the speedchange lever.To change the speed, press the speed change lever andslide it to the “L” p

8Installing or removing drill bitTo install the bit, place it in the chuck as far as it will go.Tighten the chuck by hand. Place the chuck key in each

9Blow-out bulb (optional accessory)After drilling the hole, use the blow-out bulb to clean the dustout of the hole.Drilling operationCAUTION:• Pressin