Makita RT0700C Manuál s instrukcemi

1 ENGLISH (Original instructions) INSTRUCTION MANUAL DOUBLE INSULATION IMPORTANT: Read Before Using. Trimmer RT0700C 011833

10 Install the pulley on the tool by pressing the shaft lock and firmly tightening the pulley with a wrench. 12 011859 Place the collet cone and scre

11 Mount the trimmer base with four screws and the grip attachment (optional accessory) with two screws on the offset base plate. Screw a bar type gri

12 fasten the stopper pole firmly. Now, your predetermined depth of cut can be obtained by loosening the lock lever and then lowering the tool body un

13 the wing bolts to secure the straight guide in place. When cutting, move the tool with the straight guide flush with the side of the workpiece. A

14 For the plunge base (optional accessory) 12 011853 Use the dust nozzle for dust extraction. Install the dust nozzle on the tool base using the thu

15 OPTIONAL ACCESSORIES CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use

16 Drill point flush trimming bit 005120 mmDAL 1L 2666E 1/4"66018L 328888 2060 35 011930 Drill point double flush trimming bit 005121 mmD A

17 Ball bearing corner rounding bit 005131 mmD A 1 A 2 L 1 L 2 L 3 R661/4"3.533.5621401015837721884010 3.56 006466 Ball bearing chamfering bit

18

19

2 ENGLISH (Original instructions) SPECIFICATIONS Model RT0700C Collet chuck capacity 6 mm, 8 mm, 1/4" or 3/8" No load speed (min-1) 10,000

20 Makita CorporationAnjo, Aichi, Japanwww.makita.com 885025A229

3 Conforms to the following European Directives: 2006/42/EC And are manufactured in accordance with the following standards or standardised documents:

4 Power tool use and care 18. Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job be

5 FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Ad

6 ASSEMBLY CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Installing or removing tri

7 • When using the trimmer shoe, the straight guide or the trimmer guide, be sure to keep it on the right side in the feed direction. This will help

8 distance between the bit and the straight guide. At the desired distance, tighten the wing nut securely. When cutting, move the tool with the straig

9 123 001998 When cutting, move the tool with the guide roller riding the side of the workpiece. Tilt base (optional accessory) Tilt base (optional a