Makita DCS411 Manuál s instrukcemi stáhnout pdf (Strana 19)

Electrode gap

The electrode gap must be 0.5 mm.

Checking the ignition spark

‑ Press the loosened spark plug with the ignition cable rmly

connected against the cylinder using insulated pliers (not

near the spark plug opening).

‑ ON/OFF switch in the "

I" (ON) position.

‑ Pull the starter cable hard.

If the function is correct, an ignition spark must be visible near

the electrodes.

Cleaningtheairlter

‑ Remove the lter cover (E/1) (2 screws).

CAUTION:

Pull the choke (E/2) to shut the choke valve and to prevent dirt

particles from entering the carburetor.

‑ Pull the air lter (

E/3) off the carburetor.

‑ Cover the carburetor with a clean cloth.

‑ Grasp the top and bottom sections of the air lter as shown

in gure F and pull apart.

CAUTION:

To prevent injury to the eyes, do NOT blow out dirt parti-

cles!

Donotusefueltocleantheairlter

‑ Clean the air lter with a soft brush.

‑ If the lter is very dirty, clean it in lukewarm water with dish

‑

washing detergent.

‑ Let the air lter

dry completely.

‑ Put the top and bottom sections back together.

‑ Before re‑installing the air lter, check the choke valve for

dirt particles. If there are any, remove them with a brush.

If the lter is very dirty, clean it frequently (several times a day),

because only a clean air lter provides full engine power.

Important:

For sawing dry wood and working on dusty ground we recommend

using a Robkookairlter (available as an accessory). The

Robkook lter keeps out even the smallest dust particles.

CAUTION:

Replacedamagedairltersimmediately.Piecesofclothor

large dirt particles can destroy the engine!

Replacing the spark plug

0.5 mm

CAUTION:

Do not touch the spark plug or plug cap if the engine is

running(highvoltage).

Switchofftheenginebeforestartinganymaintenancework.

Ahotenginecancauseburns.Wearprotectivegloves!

The spark plug must be replaced in case of damage to the

insulator, electrode erosion (burn) or if the electrodes are very

dirty or oily.

‑ Remove the lter cover (see "Cleaning the air lter" above,

Fig. E/1).

‑ Pull the plug cap (

G/1) off the spark plug. Use only the

combination wrench supplied with the saw to remove the

spark plug.

CAUTION: Use only the following spark plugs:

NGK BPMR 6F or CHAMPION RDJ-7Y.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Komentáře k této Příručce

Žádné komentáře

Makita DCS411 Manuál s instrukcemi Strana 19

Komentáře k této Příručce

Související produkty a manuály pro Elektrické řetězové pily Makita DCS411